User manual

Appendix

1-Pilot Solution

14-Channel

RC Receiver

(Futaba)

3-Position Switch

7(AUX2)

1(AILE)

2(ELEV)

4(RUDD)

3(THRO)

3-Position Switch

2-Position Switch

Gimbal Control

Aircraft Control

· This is example connection. Prepare one 14-channel TX/RC receiver for aircraft and gimbal control.

· Setup Aileron, Elevator, Throttle，Rudder channels on TX for aircraft roll, elevator, throttle, rudder control,

and TX AUX2 for aircraft control modes(Please refer to Autopilot System User Manual).

· Choose three 3-position switches for ROLL, TILT, and PAN rotation control. Switch center position is 0

velocity and end positions are maximum velocity.

· Choose one 3-position switch/channel as Z15 Working Modes switch (MODE).

· Choose one 2-position switch/channel as camera shutter control switch (SHUT), and one as HDMI

switch (AUX1).

· Connect the receiver to GCU and Autopilot System MC correctly.