User manual

12
Camera Wiring/Shutter Control
Camera Wiring
Connect the camera correctly, since the gimbal works with a HDMI-AV module for converting video signal
format and transforming TX signal into shutter control signal.
Ensure camera is setup first, and then follow the procedures to connect camera and gimbal.
HDMI－AV
Interface
Camera HDMI Port
Infrared Signal
Emission Unit
Camera
Shutter Control
Module
Shutter
Camera Lens
Remote Sensor
Gimbal LED Indicator
HDMI-AV
Module
IMU
Step1: Connect the gimbal HDMI-AV module to camera HDMI port with a HDMI-AV connection cable.
Step2: Make sure the infrared signal emission unit is aligned to the remote sensor.
Notices:
 When disconnect the cable between HDMI-AV module and camera, dismount the camera, and
unplug the HDMI-AV interface.
 Make sure the infrared signal emission unit is aligned to the remote sensor.
Shutter Control
Z15 enables transforming TX command into shutter control signal, please set one 2-position switch/channel
for remote shutter control.
Set the Drive Mode as Remote Cdr. in Camera Menu, and make sure the shutter control module is correctly
mounted and wired.
Whichever 2-position switch on your transmitter selected, wire the right channel of receiver to SHUT port.
One switch toggle is for one shooting.
For example, toggle twice will achieve two shootings.