Service manual

CTXS-J, CTXS-H, FTXS-H Series SiUS12-928_B
85 Operation Manual
 To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
1. Press .
“ ” is displayed.
“ ” blinks.
2. Press until the time setting reaches the point
you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes. Holding
down either button changes the setting rapidly.
3. Press again.
• The TIMER lamp lights up.
Display
 To cancel ON TIMER operation
Press .
 To combine ON TIMER and OFF TIMER
• The TIMER lamp goes off.
• A sample setting for combining the two timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
ATTENTION
 In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
21