Service manual
7HVW2SHUDWLRQ 6L(1%(
7HVW2SHUDWLRQ
2SHUDWLRQZKHQ3RZHULV7XUQHG2Q
:KHQ7XUQLQJ2Q3RZHU)LUVW7LPH
7KHXQLWFDQQRWEHUXQIRUXSWRPLQXWHVWRDXWRPDWLFDOO\VHWWKHPDVWHUSRZHUDQGDGGUHVV
LQGRRURXWGRRUDGGUHVVHWF
6WDWXV
:KHQ7XUQLQJ2Q3RZHUWKH6HFRQG7LPHDQG6XEVHTXHQW
7DSWKH5(6(7EXWWRQRQWKHRXWGRRUXQLW3&ERDUG2SHUDWLRQEHFRPHVSRVVLEOHIRUDERXW
PLQXWHV,I\RXGRQRWSXVKWKH5(6(7EXWWRQWKHXQLWFDQQRWEHUXQIRUXSWRPLQXWHVWR
DXWRPDWLFDOO\VHWPDVWHUSRZHU
6WDWXV
:KHQDQ,QGRRU8QLWRU2XWGRRU8QLWKDVEHHQ$GGHGRU,QGRRURU
2XWGRRU8QLW3&%RDUGKDVEHHQ&KDQJHG
%HVXUHWRSXVKDQGKROGWKH5(6(7EXWWRQIRUVHFRQGV,IQRWWKHDGGLWLRQFDQQRWEH
UHFRJQL]HG,QWKLVFDVHWKHXQLWFDQQRWEHUXQIRUXSWRPLQXWHVWRDXWRPDWLFDOO\VHWWKH
DGGUHVVLQGRRURXWGRRUDGGUHVVHWF
6WDWXV
2XWGRRUXQLW 7HVWODPS+3%OLQNV
&DQDOVREHVHWGXULQJRSHUDWLRQGHVFULEHGDERYH
,QGRRUXQLW ,I21EXWWRQLVSXVKHGGXULQJRSHUDWLRQGHVFULEHGDERYHWKH8+
PDOIXQFWLRQLQGLFDWRUEOLQNV
5HWXUQVWRQRUPDOZKHQDXWRPDWLFVHWWLQJLVFRPSOHWH
2XWGRRUXQLW 7HVWODPS+3%OLQNV
&DQDOVREHVHWGXULQJRSHUDWLRQGHVFULEHGDERYH
,QGRRUXQLW ,I21EXWWRQLVSXVKHGGXULQJRSHUDWLRQGHVFULEHGDERYHWKHRSHUDWLRQODPS
OLJKWVEXWWKHFRPSUHVVRUGRHVQRWRSHUDWH5HWXUQVWRQRUPDOZKHQ
DXWRPDWLFVHWWLQJLVFRPSOHWH
2XWGRRUXQLW 7HVWODPS+321
&DQDOVREHVHWGXULQJRSHUDWLRQGHVFULEHGDERYH
,QGRRUXQLW ,I21EXWWRQLVSXVKHGGXULQJRSHUDWLRQGHVFULEHGDERYHWKH8+RU8
PDOIXQFWLRQLQGLFDWRUEOLQNV5HWXUQVWRQRUPDOZKHQDXWRPDWLFVHWWLQJLV
FRPSOHWH
A
A
O
pera
ti
ng w
ith
se
t
a
i
r
fl
ow ra
t
e
20E :
-2-4
Suction air temp.
Set temp.
b
a
(3)
(2)
(1)
*9. Fan operation
By setting the remote controller to Fan, the fan
will operate with thermostat OFF in set
temperature control operation mode.
*10. Set wind direction
According to wind direction instruction from the
remote controller, the wind direction is set to
100% horizontal while in heating operation.
*11. Fan
According to fan speed instruction from the
remote controller, the fan is put into operation in
LL mode while in heating operation.
*12. Wind direction
When the heating thermostat turns OFF, the wind direction will be set to 100% horizontal.
*13. Hot start
If the condenser inlet temperature exceeds 34°C at the time of starting operation or after the
completion of defrost operation, or until 3 minutes pass or Tc is above 52°C, hot starting will be
conducted.
*14. Thermostat status
*15. Outlet air temperature drop protection
When the set temperature is b
elow 24°C or the electronic expansion valve opening is small, the
protection will be activated.
Electronic
expansion valve
Closed
Caution When the 400 volt power supply is applyed to "N" phase by mistake,
replace Inverter PC board (A2P) and control transformer (T1R, T2R) in
switch box together.
(V0847)