Instruction manual

English 7
HOW TO CLEAN AIR OUTLET AND OUTSIDE
PANELS
• Clean with soft cloth.
• When it is difficult to remove stains, use water or
neutral detergent.
• When the flap is extremely contaminated, remove
it as below and clean or exchange it.
(Flap for exchange is optional)
NOTE
• Do not use gasoline, benzene, thinner, polishing
powder, liquid insecticide. It may cause discolor-
ing or warping.
• Do not let the indoor unit get wet. It may cause an
electric shock or a fire.
• Do not scrub firmly when washing the blade with
water.
The surface sealing may peel off.
• Do not use water or air of 50°C or higher for clean-
ing air filters and outside panels.
HOW TO CLEAN THE SUCTION GRILLE
1. Open the suction grille.
Refer to “HOW TO CLEAN THE AIR FILTER”
(Refer to Fig. 1)
2. Detach the suction grille.
1 Detach the two strings attaching the suction
grille to the indoor unit.
2 With the suction grille in the open position,
remove the suction grille by pushing it up as
shown. (Refer to Fig. 4)
3. Remove the air filter
Refer to “HOW TO CLEAN THE AIR FILTER”.
4. Clean the suction grille.
Wash with a soft bristle brush
and neutral detergent or
water, and dry throughly.
• When very grimy
Directly apply the type of detergent used for
cleaning ventilation fans or ovens, wait 10 min-
utes, and then rinse with water.
NOTE
• Do not wash the air conditioner with hot water of
more than 50°C, as doing so may result in discol-
oration and/or deformation.
Fig. 4
5. Fix the air filter
Refer to “HOW TO CLEAN THE AIR FILTER ”.
6. Reattach the suction grille.
Refer to item No. 2.
7. Close the suction grille.
Refer to item No. 1.
HOW TO DETACH AND REATTACH THE AIR
FLOW FLAP
1. Detaching the flap
Open the pawl on each end and pull the flap out
towards you. (Refer to Fig. 5)
2. Reattaching the flap
Align the flap’s pawls with the bumps on both
ends of the air outlet and push gently.
(Refer to Fig. 6)
NOTE
• When washing the flap with water, use only soft
brush or neutral detergent.
START UP AFTER A LONG STOP
Confirm the following
• Check that the air inlet and outlet are not blocked.
Remove any obstacle.
• Check if the earth is connected.
Might there be a broken wire somewhere?
Contact your dealer if there are any problems.
Clean the air filter and outside panels
• After cleaning the air filter, make sure to attach it.
Turn on the main power supply switch
• The display on the remote controller will be shown
when the power is turned on.
• To protect the unit, turn on the main power switch
at least 6 hours before operation.
WHAT TO DO WHEN STOPPING THE SYS-
TEM FOR A LONG PERIOD
Turn on FAN OPERATION for a half day and dry
the unit.
• Read the operation manual attached to the
remote controller.
Cut off the power supply.
• When the main power switch is turned on, some
watts of electricity is being used even if the sys-
tem is not operating.
Turn off the main power supply switch for saving
energy.
Fig. 5
Fig. 6