Service manual
:LULQJ'LDJUDPVIRU5HIHUHQFH 6L(1
$SSHQGL[
);=4000009(
3D038359
Note:3
Control Box
1.
Receiver/display unit
Notes:
: Terminal block,
: Connector
: Field wiring
2. In case using central remote controller, connect it to the unit in accordance with the attached installation manual.
3. X23A is connected when the wireless remote controller kit is being used.
4. When connecting the input wires from outside, forced off or on/off control operation can be selected by remote control.
In details, refer to the installation manual attached the unit.
6. Symbols shows as follows:
PNK:PINK WHT:White YLW:Yellow ORG:Orange BLU:Blue BLK:Black RED:Red BRN:Brown
5. Remote
control model varies according to the combination system, confirm engeneering materials and catalogs, etc. before
connecting.
Input from outside
Note-4
Transmission wiring
central remote controller
Note-2
Wired remote
control
Note:3
BS1 Push button (On/Off)
H1P Light emitting diode
(On-red)
H2P Light emitting diode
(Timer-green)
H3P Light emitting diode
(Filter sign-red)
H4P Light emitting diode
(Defrost-orange)
SS1 Selector switch
(Main/Sub)
SS2 Selector switch
(Wireless address set)
Connector for optional parts
X16A Connector
(Adapter for wiring)
X18A Connector
(Wiring adapter for
electorical appendices)
A1P Printed circuit board
C1C Capacitor (M1F)
F1U Fuse ( B, 5A, 250V)
HAP Light emitting diode
(Service monitor-green)
KPR Magnetic relay (M1P)
M1F Motor (Indoor fan)
M1P Motor (Drain pump)
M1S Motor (Swing flap)
Q1M Thermo protector (M1F embedded)
R1T Thermistor (Air)
R2T Thermistor (Coil-liquid)
R3T Thermistor (Coil-gas)
S1L Float switch
T1R Transformer (220-240V/22V)
V1TR Triac
X1M Terminal block
X2M Terminal block
Y1E Electronic expansion valve
Wired remote control
R1T Thermistor (Air)
SS1 Selector switch (Main/Sub)
Infrared remote control
Receiver/Display unit
A3P Printed circuit board
A4P Printed circuit board
Power supply