Service manual
:LULQJ'LDJUDPVIRU5HIHUHQFH 6L(1
$SSHQGL[
,QGRRU8QLW
);&400009(
3D039556
Note-5
Input from outside
Note-3
Transmission wiring
central remote control
Wired remote control
(Optional accessory)
Note-4 Receiver/Display unit
(Wireless remote control)
Electric parts box
Power supply
Indoor Unit
A1P Printed circuit board
C1C Capacitor (M1F)
F1U Fuse ( B, 5A, 250V)
HAP Light emttting diode
(Service monitor-green)
K1R-K3R Magnetic relay (M1F)
KAR Magnetic relay (M1S)
KPR Magnetic relay (M1P)
M1F Motor (Indoor fan)
M1P Motor (Drain pump)
M1S Motor (Swing flap)
Q1M Thermo switch (135C)
or (145C notes 8)
(M1F embedded)
R1T Thermistor (Air)
K1R-K3R Thermistor (Coil)
S1L Float switch
S1Q Limit switch
(Swing Flap)
T1R Transformer (220-240V/22V)
X1M Terminal strip (Power)
X2M Terminal strip (Control)
Y1E Electronic
expansion valve
H3P Light emitting diode
(Filter sign-red)
H4P Light emitting diode
(Defrost-orange)
SS1 Selector switch
(Main/Sub)
SS2 Selector switch
(Wireless address set)
Connector for optional parts
X18A Connector (Wiring
adaptor for electorical
appendices)
X23A Connector
(Wireless remote
control)
1. : Terminal block, :Connector
2. : Field wiring
3. In case using central remote control, connect it to the unit in accordance
with the attached instruction manual.
4. X23A is connected when the infrared remote control kit is being used.
5. When connecting the input wires from outside, forced off or on/off control
operation can be selected by remote controller. In details, refer to the
installation manual attached the unit.
6. Symbols shows as follows.
PNK:PINK WHT:White YLW:Yellow ORG:Orange
BLU:Blue BLK:Black RED:Red BRN:Brown
: Connector
7. Use copper conductors only.
8. Only FXCQ63MVE.
Notes
Wired remote control
R1T Thermistor (Air)
SS1 Selector switch
(Main/Sub)
Receiver/Display unit
(attached to wireless
remote control)
A2P Printed circuit board
A3P Printed circuit board
BS1 Push button (On/Off)
H1P Light emitting diode
(On-red)
H2P Light emitting diode
(Timer-green)