Installation manual

English 6
English
When connecting to an HA system5.
Take out the terminal block and electrical wiring box, and open the lid for the electrical wiring box.1)
Remove the 2 screws, and open the lid for the electrical wiring box.2)
Attach the connection cord to the S21 connector and pull the harness out through the notched part in the fi gure.3)
3)-1. Remove a
fixing screw.
3)-2. Remove the tabs (3 positions),
and detach the terminal block.
3)-3. Connect the connection cord to
the S21 connector, and pull it
through as shown.
Be careful the connection
cord is not caught.
Tab
S21
Top view
Pull the harness around, as shown in the fi gure, and replace a fi xing screw as it was.4)
Attach the tabs (3 positions), and
return the terminal block to its
original position.
At this time, be careful the cords
are not caught.
Tab
Screw
Replace the electrical wiring cover as it was.5)
01_EN_3P276870-1.indb 601_EN_3P276870-1.indb 6 2/23/2011 5:03:59 PM2/23/2011 5:03:59 PM