Service manual

Operation Manual SiBE041134
52 Operation Manual
2.10 ON TIMER Operation
ON TIMER Operation
 To use ON TIMER operation
 To cancel ON TIMER operation
 To combine ON TIMER and OFF TIMER
• Check that the clock is correct.
If not, set the clock to the present time.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
• “ ” and day of the week disappear from the LCD.
• “ ” and setting time are displayed on the LCD.
• The TIMER lamp lights yellow.
1. Press .
3. Press again.
2. Press until the time setting reaches the
point you like.
• “ ” is displayed on the LCD.
• “ ” blinks.
• “ ” and setting time disappear from the LCD.
• “ ” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
• A sample setting for combining the 2 timers is shown below.
Press .
Display
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
 In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.