Service manual

SiBE12-816_D RA Indoor Unit
Operation Manual 166
 To use ON TIMER operation
1. Press “ON TIMER button”.
is displayed.
blinks.
3. Press “ON TIMER button” again.
• The TIMER lamp lights up.
4. Press “CANCEL button”.
• The TIMER lamp goes off.
 To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
4
2
1, 3
• Check that the clock is correct. If not, set
the clock to the present time.
2. Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
 To cancel ON TIMER
operation
 In the following cases, set the timer again.
•
After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.