Installation manual

5
Name of Parts
Indoor Unit
Air outlet
Panel tab
Louvers (horizontal blades)
Page 13
Room temperature
sensor
It detects the air temperature •
around the unit.
Fins (vertical blades)
The fi ns are inside of the air outlet. •
Page 13
Model name plate
Air inlet Front panel
TIMER lamp (yellow)
Page 16,17
OPERATION lamp
(green)
Signal receiver
It receives signals from the remote •
controller.
When the unit receives a signal, you •
will hear a beep sound.
Case Sound type
Operation start beep-beep
Setting changed beep
Operation stop long beep
Display
Indoor unit ON/OFF switch
Press this switch once to start operation.•
Press once again to stop it.
The operation mode refer to the following table.•
Model Mode Temperature setting Airfl ow rate
COOLING ONLY COOL 72°F (22°C) AUTO
HEAT PUMP AUTO 77°F (25°C) AUTO
This switch is useful when the remote controller is missing.•
01_EN_3P276856-2.indd 501_EN_3P276856-2.indd 5 12/20/2010 10:57:07 AM12/20/2010 10:57:07 AM