Installation manual

23
Care and Cleaning
Take off the titanium apatite 1.
photocatalytic air-purifying
fi lter.
Open the front panel and pull out the air fi lters.•
Hold the recessed parts of the frame and unhook •
the 4 claws.
Claw Claw
Clean or replace the titanium 2.
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
Vacuum dust, and soak in lukewarm 2-1
water or water for about 10 to
15 minutes if dirt is heavy.
Do not remove the fi lter from frame when washing •
with water.
After washing, shake off remaining 2-2
water and dry in the shade.
Since the material is made out of polyester, do not •
wring out the fi lter when removing water from it.
[Replacement]
Remove the tabs on the fi lter
frame and replace with a new
fi lter.
Do not throw away the fi lter frame. Reuse the fi lter •
frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
Dispose of the old fi lter as non-fl ammable waste.•
Set the fi lters as they were 3.
and close the front panel.
Press the front panel at both sides and the center.•
NOTE
Operation with dirty fi lters:•
cannot deodorize the air, –
cannot clean the air, –
results in poor heating or cooling, –
may cause odor. –
Dispose of old fi lters as non-fl ammable waste. •
To order titanium apatite photocatalytic air-purifying •
fi lter contact to the service shop there you purchased
the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying fi lter (without frame) 1 set
Part No. KAF970A46
Titanium apatite photocatalytic air-purifying fi lter 
01_EN_3P272441-1.indd 2301_EN_3P272441-1.indd 23 12/14/2010 1:40:24 PM12/14/2010 1:40:24 PM