Installation manual

10
English
 Turn the breaker on
After the power is turned on, the louver of the indoor unit opens and closes once to •
set the reference position.
Checks on remote controller settings 
This remote controller is common to the heat pump model and •
cooling only model. Use the DIP switch on the remote
controller to set the heat pump model or cooling only model.
Refer to the following explanation and make the setting as •
shown in the illustration.
For customers of heat pump model: Set to H/P•
For customers of cooling only model: Set to C/O•
H/P C/O
DIP switch
To set the clock 
Press 1. .
“ ” is displayed.
“
” and “ ” blink.
Press 2. to set the current day of the week.
Press
3. .
“ ” blinks.
Press 4. to set the clock to the present time.
Holding down • or rapidly increases or decreases the time display.
Press 5. .
Point the remote controller at the indoor unit when pressing the buttons.•
“ ” blinks.
01_EN_3P272441-1.indd 1001_EN_3P272441-1.indd 10 12/14/2010 1:39:55 PM12/14/2010 1:39:55 PM