Service manual

SiEBE12-625 Instruction
List of Functions 167
1. Open the front panel.
2. Pull out the air filters.
• Push a little upwards the tab at the center of
each air filter, then pull it down.
3. Take off the Titanium Apatite
Photocatalytic Air-Purifying
filter.
• Press the top of the air-
cleaning filter onto the tabs
(3 tabs at top). Then press
the bottom of the filter up
slightly, and press it onto the
tabs (3 at bottom).
4. Clean or replace each filter.
See figure.
5. Set the air filter and the Titanium Apatite Photocatalytic
Air-Purifying filter as they were and close the front
panel.
• Press the front panel at both sides and the center.
 Air Filter
1. Wash the air filters with water or clean them with vacuum cleaner.
• If the dust does not come off easily, wash them with neutral
detergent thinned with lukewarm water, then dry them up in the
shade.
• It is recommended to clean the air filters every two weeks.
 Titanium Apatite Photocatalytic Air-purifying Filter (gray)
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning agent.
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing water
from it.
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
• Dispose of the old filter as flammable waste.
Filters
tabs (3 tabs at top)
tabs (3at bottom)