Service manual

Instruction SiEBE12-625
138 List of Functions
 To start COMFORT AIRFLOW operation
5. Press the “COMFORT AIRFLOW button”.
• The flap orientation will change, preventing air from blowing directly on the occupants of the
room.
• “ ” is displayed on the LCD.
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down
 To cancel COMFORT AIRFLOW operation
5. Press the “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• “ ” disappears from the LCD.
NOTE
• When “SWING button ” is selected, the flap swinging range depends on the
operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, wich tends to collected at the
bottom of the room, and hot air, which tends to collect near the ceiling, troughout
the room, preventing areas of cold and hot developing.
 ATTENTION
• Always use a remote control to adjust the flap angle.
If you attempt to move it forcibly with hand when it is swinging, the mechanism may
be broken.
• Always use a remote control to adjust the louvers angles.
In COOL or DRY mode
In HEAT or FAN mode
In COMFORT AIRFLOW mode
COOL/DRY
HEAT
HEAT
STOP
STOP
STOP
FAN
approx.
approx.
approx.
COOL