Service manual

Instruction SiEBE12-625
136 List of Functions
 To 3-D Airflow
1.3 Press the “SWING button ” and the “SWING button ”:
The “ ” and “ ” display will light up and the flap and louvers will move in turn.
 To cancel 3-D Airflow
2.4 Press either the “SWING button ” or the “SWING button ”.
Notes louvers angles
Notes on flap angle
 ATTENTION
• Always use a remote controller to adjust the louvers angles. In side the air outlet, a fan is rotating at a high speed.
• When “Swing button” is selected, the flaps swinging range depends on the
operation mode. (See the figure)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, which tends to collected
at the bottom of the room, and hot air, which tends to collect near the ceiling,
throughuit the room, preventing areas of cold and hot developing..
 ATTENTION
• Always use a remote control to adjust the flaps angle.
If you attempt to move it forcibly with hand when it is swinging, the
mechanism may be broken.
• Be careful when adjusting the louvres. Inside the air outlet, a fan is rotating at
a high speed.
In DRY mode or COOL mode
In HEAT or FAN mode
STOP
COOL
approx. 10°~40°
DRY
approx. 5°~35°
STOP
HEAT
approx. 15°~55°
FAN
approx. 5°~55°