Service manual

Instruction SiEBE12-625
132 List of Functions
 To start COMFORT AIRFLOW operation
3. Press “COMFORT AIRFLOW button”.
• The flap position will change, preventing air from blowing directly on the occupants of the room.
• " " is displayed on the LCD
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down
 To cancel COMFORT AIRFLOW operation
4. Press “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFROT AIRFLOW mode.
• " " disappears from the LCD
Notes on COMFORT AIRFLOW operation
Notes on flaps and louvers angles
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time.
Priority is given to POWERFUL operation.
• When “ SWING button ” is selected, the flaps swinging range depends on the
operation mode. (See the figure.)
 ATTENTION
• Always use a remote control to adjust the flaps angle. If you attempt to move
it forcibly with hand when it is swinging, the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the air outlet, a fan is rotating at
a high speed.
In DRY mode or COOL mode
In HEAT mode
In FAN mode
When stop operation
Upper limit
Lower limit
When stop operation
Upper limit
Lower limit
When stop operation
Upper limit
Lower limit