Service manual

SiEBE12-625 Instruction
List of Functions 109
 Outdoor Unit
 Indoor Unit
 Outdoor Unit
Appearance of the outdoor unit may differ from some models.
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter
• These filters are attached to the inside of
the air filters
3. Air inlet
4. Front panel
5. Panel tab:
6. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
7. Display
8. Air outlet
9. Flap (horizontal blade)
10. Louvers (vertical blades)
• The Louvers are inside of the air outlet.
11. Operation Lamp (green)
12. TIMER lamp (yellow)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refer to the following
table.
• This switch is useful when the remote
control is missing.
15. Room temperature sensor:
• It senses the air temperature around the
unit.
16. Signal receiver:
• It receives signals from the remote
controller.
• When the unit receives a signal, you will
hear a short beep
• Operation start ...........beep-beep
• Settings changed .......beep
• Operartion stop ..........beeeeep
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
21. Earth terminal
• It is inside of this cover.
19
20
21
18
17
Mode Temperature
setting
Air flow
rate
FTKS COOL 22°C AUTO
FTXS AUTO 25°C AUTO