Specifications

SiBE04-101 Instruction
System Configuration 69
Preparation Before Operation
■■
■■
■ Setting the air purifying filters
● When opening the front grille, use a robust and
stable stool and watch your steps carefully.
Indoor unit
● Holding down ( ) or ( ) button
rapidly increases or decreases the time display.
NOTE
■■
■■
■ Setting the clock
Press .
Press
TEMP
to set the clock to the
present time.
■■
■■
■ Turn the breaker ON
● Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
1
AM
is displayed.
2
AM
Display
blinks.
3
Please note
● The air conditioner always consumes 15 – 35
watts of electricity even while it is not operating.
● If you are not going to use the air conditioner for a
long period, for example in spring or autumn, turn
the breaker OFF.
● Use the air conditioner in the following conditions.
Press .
PM
Display
blinks.
(Now the clock is set.)
Mode
COOL
/ DRY
HEAT
Operating conditions
• Outdoor temperature : –10 to 46 ˚C
• Indoor temperature : 15 to 28 ˚C
• Indoor humidity : 80% max.(*1)
• Outdoor temperature : –15 to 24 ˚C
• Indoor temperature : 10 to 30 ˚C
If operation is continued out of this range
• A safety device may work to stop the
operation.
(In multi system, it may work to stop
the operation of the outdoor unit only.)
• Condensation may occur on the indoor
unit and drip.
• A safety device may work to stop the
operation.
(*1) Use in humidity 60 % or lower when using the unit
at an outdoor temperature of 10˚C or lower.
PM
Display
Tips for saving energy
● Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 26˚C – 28˚C
For heating: 20˚C – 24˚C
● Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
● Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two weeks.
Open the front grille.
● Hold the grille by the tabs on the two sides
and pull it until it stops.
1
Pull out the air filters.
● Push the tab at the
center of each air filter,
then pull it down.
2
O
N
O
F
F
Set the air purifying
filters.
● Attach an air purifying
filter to each air filter.
3
4
Set the air filters in their original
positions and close the front grille.
O
N
O
F
F
● Push the grille at the 5 points indicated by
.
● Operation without air filters may result in
troubles as dust will accumulate inside the
indoor unit.
SiBE04-101.book Page 69 Monday, October 15, 2001 3:08 PM