Specifications

SiBE04-101 Instruction
System Configuration 53
Preparation Before Operation
■■
■■
■ Setting the air purifying filters
Indoor unit
● Holding down ( ) or ( ) button
rapidly increases or decreases the time display.
NOTE
■■
■■
■ Setting the clock
Press .
Press
to set the clock to the
present time.
■■
■■
■ Turn the breaker ON
● Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
Pull out the air filters.
● Push upwards the
tab at the center of
each air filter, then
pull it down.
2
Open the front grille.
● Hold the grille by the tabs on the two sides
and lift it until it stops with a click.
(about 60˚)
1
û
C
Set the air purifying filters.
● Attach an air purifying filter to each air filter.
(See page 16 “Care and cleaning”)
Set the air filters in their original
positions and close the front grille.
● Operation without air filters may result in
troubles as dust will accumulate inside the
indoor unit.
3
4
1
is displayed.
2
blinks.
3
Please note
● The air conditioner always consumes 15 – 35 watts of
electricity even while it is not operating.
●
If you are not going to use the air conditioner for a long period,
for example in spring or autumn, turn the breaker OFF.
● Use the air conditioner in the following conditions.
Press .
blinks.
(Now the clock is set.)
Mode
COOL/
DRY
HEAT
Operating conditions
Outdoor temperature
RXD : –10 to 46 ˚C
2~3MX : 21 to 43 ˚C
4MX : 10 to 43 ˚C
Indoor temperature : 15 to 28 ˚C
Indoor humidity : 80% max. (*1)
Outdoor temperature
RXD : –15 to 24 ˚C
2~4MX : –10 to 24 ˚C
Indoor temperature : 10 to 30 ˚C
If operation is continued out of this range
• A safety device may work to stop the
operation.
(In multi system, it may work to stop
the operation of the outdoor unit only.)
• Condensation may occur on the
indoor unit and drip.
• A safety device may work to stop the
operation.
(*1) Use in humidity 60% or lower when using the unit
at an outdoor temperature of 10˚C or lower.
Tips for saving energy
● Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 26˚C – 28˚C
For heating: 20˚C – 24˚C
● Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
● Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two w
eeks.
SiBE04-101.book Page 53 Monday, October 15, 2001 3:08 PM