Specifications

Si01-406 Instructions
System Configuration 75
FT50/60CV1A
Care and Cleaning
CAUTION
■ Indoor unit, Outdoor unit and Remote controller
1. Wipe them with dry soft cloth.
■ Front grille
1. Open the front grille.
• Hold the grille by the tabs on the two sides
and lift it until it stops with a click.
2. Remove the front grille.
• Open the front panel further while slid-
ing it to either the left or right and pulling
it toward you. This will disconnect the
rotation dowel on one side. Then discon-
nect the rotation dowel on the other side
in the same manner.
3. Clean the front grille
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
•
In case of washing the grille with water, dry it with cloth, dry it up in the shade after washing.
4. Attach the front grille
• Align the rotation dowels on the left and right of the front panel with
the slots, then push them all the way in.
• Close the front panel slowly. (Press the panel at both sides and the
center.)
CAUTION
Units
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front grille, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front grille, support the grille securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40
°
C, benzine, gasoline, thinner, nor other volatile oils, pol-
ishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front grille is securely fixed.
Before cleaning, be sure to stop the operation and
turn the breaker OFF.