Service manual

ESIE03–01 Disassembly and Maintenance: Indoor Units
Part 5 – Disassembly and Maintenance 5–57
3
5
1
5
3 Disconnect wires and connectors from PCB.
4 Arrange wire harness to avoid interference with next process.
Step Action
Heat exchanger
thermistor
Suction air thermistor
LED lamp (green)
LED lamp (green)
Drain pump
Connecting wire
terminal strip
To connecting wire
terminal strip
Fan motor
Swing motor
Remote controller
terminal strip
Earth terminal for
remote controller
Earth
To power supply PCB
Caution
This work should be done by two personnel.
If drain water remain in the pan, it may drop
and stain onthe floor. Make sure to check if
no drain water remain in the pan, or cover
the floor with vinyl sheet before disassem-
bling work.