Service manual

ESIE03–01 Troubleshooting

Part 3 – Troubleshooting 3–9

2 Press the UP or DOWN button and change the UNIT No. until the receiver of the remote

controller starts to beep.

3 Press the MODE selector button.The left “0” (upper digit) indication of the error code

flashes.’

Step Action

If you hear... Then...

3 short beeps Follow all steps below.

1 short beep Follow steps 3 and 4. Continue the

operation in step 4 until you hear a con-

tinuous beep. This continuous beep

indicates that the error code is con-

firmed.

1 continuous beep There is no abnormality.

DOWN

MODE