00_CV_3PN05140-1.
01_CV_3PN05140-1.
01_CV_3PN05140-1.fm Page 2 Wednesday, October 2, 2002 1:05 PM Thank you for purchasing this Daikin air conditioner. Carefully read this operation manual before using the air conditioner. It will tell you how to use the unit properly and help you if any trouble occurs. After reading the manual, file it away for future reference. Óáò åõ÷áñéóôïýìå ðïõ áãïñÜóáôå ôç óõóêåõÞ êëéìáôéóìïý. ÄéáâÜóôå ðñïóåêôéêÜ áõôÝò ôéò ïäçãßåò ÷ñÞóçò ðñéí íá ÷ñçóéìïðïéÞóåôå ôç óõóêåõÞ êëéìáôéóìïý.
02_EN_3PN05140-1.fm Page 1 Thursday, November 14, 2002 3:37 PM CONTENTS ILLUSTRATIONS................................................. [1] 1. WHAT TO DO BEFORE OPERATION .......... 1 2. SAFETY CONSIDERATIONS ....................... 2 3. OPERATION RANGE .................................... 3 4. INSTALLATION SITE .................................... 3 5. NAME AND FUNCTION OF EACH SWITCH AND DISPLAY ON THE REMOTE CONTROLLER .............................................. 4 6. OPERATION PROCEDURE...............
02_EN_3PN05140-1.fm Page 2 Thursday, November 14, 2002 3:37 PM 2. SAFETY CONSIDERATIONS We recommend that you read this instruction manual carefully before use to gain full advantage of the function of the air conditioner, and to avoid malfunction due to erroneous handling. This air conditioner comes under the term “appliances not accessible to the general public.” • The precautions described below are WARNING and CAUTION. These are very important precautions concerning safety.
02_EN_3PN05140-1.fm Page 3 Thursday, November 14, 2002 3:37 PM Do not expose animals and plants directly to the wind from the air conditioner. Adverse influence to animals and plants may result. Do not wash the air conditioner with water. An electric shock may result. Do not install the air conditioner at any place where flammable gas may leak out. If the gas leaks out and stays around the air conditioner, a fire may break out. Be sure to install an earth leakage breaker.
02_EN_3PN05140-1.fm Page 4 Thursday, November 14, 2002 3:37 PM that all electrical work is carried out by qualified personnel according to local laws and regulations. 5 DISPLAY “ ” “ ” “ ” “ ” “ ” (OPERATION MODE) This display shows the current OPERATION MODE. For cooling only type, “ ” (Auto) and “ ” (Heating) are not installed. 6 TEST” (INSPECTION/TEST DISPLAY “ OPERATION) When the INSPECTION/TEST OPERATION BUTTON is pressed, the display shows the system mode is in.
02_EN_3PN05140-1.fm Page 5 Thursday, November 14, 2002 3:37 PM FAN SPEED CONTROL BUTTON 20 Press this button to select the fan speed, HIGH or LOW, of your choice. OPERATION MODE SELECTOR BUTTON 21 Press this button to select OPERATION MODE. AIR FLOW DIRECTION ADJUST BUTTON 22 Refer to “AIR FLOW DIRECTION ADJUST ”. NOTE • For the sake of explanation, all indications are shown on the display in Figure 1 contrary to actual running situations. 6.
02_EN_3PN05140-1.fm Page 6 Thursday, November 14, 2002 3:37 PM ADJUSTMENT For programming TEMPERATURE, FAN SPEED and AIR FLOW DIRECTION, follow the procedure shown below. TEMPERATURE SETTING Press the AIR FLOW DIRECTION ADJUST button to select the air direction as following. swing Press TEMPERATURE SETTING button and program the setting temperature. Press AIR FLOW DIRECTION ADJUST button to select the air direction of your choice. Each time this button is pressed, setting temperature rises 1°C.
02_EN_3PN05140-1.fm Page 7 Thursday, November 14, 2002 3:37 PM PROGRAM TIMER OPERATION Operate in the following order. • The timer is operated in the following two ways. • Programming the stop time ( ) .... The system stops operating after the set time has elapsed. • Programming the start time ( ) .... The system starts operating after the set time has elapsed. • The timer can be programmed a maximum of 72 hours. • The start and the stop time can be simultaneously programmed.
02_EN_3PN05140-1.fm Page 8 Thursday, November 14, 2002 3:37 PM 8. MAINTENANCE (FOR SERVICE PERSONNEL) ONLY A QUALIFIED SERVICE PERSON IS ALLOWED TO PERFORM MAINTENANCE IMPORTANT! • BEFORE OBTAINING ACCESS TO TERMINAL DEVICES, ALL POWER SUPPLY CIRCUITS MUST BE INTERRUPTED • To clean the air conditioner, be sure to stop operation, and turn the power switch off. Otherwise, an electric shock and injury may result. • Do not wash the air conditioner with water Doing so may result in an electric shock.
02_EN_3PN05140-1.fm Page 9 Thursday, November 14, 2002 3:37 PM HOW TO CLEAN AIR OUTLET AND OUTSIDE PANELS • Clean with soft cloth. • When it is difficult to remove stains, use water or neutral detergent. NOTE • Do not use gasoline, benzene, thinner, polishing powder, liquid insecticide. It may cause discoloring or warping. • Do not let the indoor unit get wet. It may cause an electric shock or a fire. • Do not use water or air of 50°C or higher for cleaning air filters and outside panels.
02_EN_3PN05140-1.fm Page 10 Thursday, November 14, 2002 3:37 PM • The system does not start when the display shows “ ” (UNDER CENTRALIZED CONTROL) and it flashes for few seconds after pressing an operation button. This is because the system is under centralized control. Flashes on the display indicates that the system cannot be controlled by the remote controller. • The system does not start immediately after the power supply is turned on. Wait one minute until the micro computer is prepared for operation.
02_EN_3PN05140-1.fm Page 11 Thursday, November 14, 2002 3:37 PM VII.DUST FROM THE UNITS • Dust may blow out from the unit after starting operation from long resting time. Dust absorbed by the unit blows out. II. If the system does not properly operate except for the above mentioned case, and none of the above mentioned malfunctions is evident, investigate the system according to the following procedures. VIII.THE UNITS GIVE OFF ODORS The unit absorbs the smell of rooms, furniture, cigarettes, etc.
00_CV_3PN05140-1.
