Specifications

38
Wall-mounted type
1
2
3
4
5
6
Wired remote controller*
1
Wired remote controller cord
5-room centralised controller*
2
Wiring adaptor for time clock/remote controller*
3
(Normal open pulse contact/normal open contact)
Titanium apatite photocatalytic air-purifying filter*
4
Wireless remote controller loss prevention chain
BRC944B2
BRCW901A03
BRCW901A08
KRC72
KRP413A1S
Notes:
*1. 3 m (BRCW901A03) or 8 m (BRCW901A08) length wired remote controller cord is necessary.
*2. A wiring adaptor (KRP413A1S) is also required for each indoor unit.
*3. Time clock and other devices should be obtained locally.
*4. Filter is a standard accessory. It should be replaced approximately every 3 years.
FTXS20DVMA FTXS25GVMA FTXS35GVMA FTXS50JVMA FTXS71JVMA
FTKS20DVMA FTKS25GVMA FTKS35GVMA FTKS50JVMA FTKS71JVMA
FTXS60JVMA
FTKS60JVMA
ItemNo.
KAF970A46
KKF917A4 KKF910A4
BP unit
Control system
No.
1
Item
REFNET joint
BPMKS967A2 BPMKS967A3
KHRP26A22T
No.
1
2
3
4
Central remote controller*
Unified on/off controller*
Schedule timer*
Interface adaptor
(For DIII-NET use)
FTK(X)S-D/G/J, FVXS-F, FLXS-B, CDK(X)S-EA, C(F)DK(X)S-C
FCQ-B, FFQ-B, FBQ-B, FHQ-B
Model No.
DCS302CA61
DCS301BA61
DST301BA61
KRP928B2S
DTA112B51
Note:
* An interface adaptor (KRP928B2S or DTA112B51) is also required for each indoor unit.
Note:
A single BP unit does not require a REFNET joint. 2 BP units require only 1 REFNET joint, and 3 BP units require only 2 REFNET joints.
Item
Floor-standing type
5-room centralised controller*
1
Wiring adaptor for time clock/remote controller*
2
(Normal open pulse contact/normal open contact)
Titanium apatite photocatalytic air-purifying filter*
3
Remote controller loss prevention chain
KRC72
KRP413A1S
KAF968A42
KKF910A4
1
2
3
4
FVXS35GV1A FVXS50GV1A
ItemNo.
FVXS25GV1A
Notes:
*1. A wiring adaptor (KRP413A1S) is also required for each indoor unit.
*2. Time clock and other devices should be obtained locally.
*3. The photocatalytic deodorising filter is a standard accessory. It can be reused indefinitely if it is exposed to direct sunlight once every 6 months. This accessory is only
required if the original filter is damaged or lost, etc.
*4. The air-purifying filter is a standard accessory. It should be replaced approximately once every 3 months. This accessory is required for the replacement of filters.
Notes:
*1. A wiring adaptor (KRP413A1S) is also required for each indoor unit.
*2. Time clock and other devices should be obtained locally.
*3. Filter is a standard accessory. It should be replaced approximately every 3 years.
Floor/ceiling-suspended dual type
5-room centralised controller*
1
Wiring adaptor for time clock/remote controller*
2
(Normal open pulse contact/normal open contact)
Photocatalytic deodorising filter with frame*
3
Photocatalytic deodorising filter without frame*
3
Air-purifying filter with frame*
4
Air-purifying filter without frame*
4
Remote controller loss prevention chain
KRC72
KRP413A1S
KAZ917B41
KAZ917B42
KAF925B41
KAF925B42
KKF917A4
1
2
3
4
5
6
7
ItemNo.
FLXS25BVMA FLXS35GVMA FLXS50GVMA FLXS60GVMA
Length 3 m (shielded wire)
Length 8 m (shielded wire)