Service manual

For BPMK928B42 · 43 Si18-201
318 Removal Procedure
1.4 Removal of Thermistor
Procedure Warning Be sure to turn off all power supplies before disassembling work.
Step Procedure Points
"
Disconnect the thermistor
harness connector from
the PCB.
"
The factory-installed
thermistors cannot be
replaced.
"
Thermistor positions and
connector pins
1
Secure a replacement
thermistor onto the
pipe with aluminium
tape.
"
Provide thermal
insulation from
above.
2
Tighten the tie-wrap to
secure the above tape.