Service manual

SiBE07-724_B Operation Manual
Operation Manual 65
17
 To use ON TIMER operation
1. Press “ON TIMER button”.
is displayed.
blinks.
2.
3.
• The TIMER lamp lights up.
 To cancel ON TIMER operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
 To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
 In the following cases, set the timer again.
2
1, 3
4
Display
(Example)
Combined
• Check that the clock is correct. If not, set
the clock to the present time.
Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
Press “ON TIMER button”
again.
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
3P196326-8C
3P196326-9C