Installation manual

ManualsBrandsDaikin ManualsAir ConditionerFDXS25E7VMB

MODELS

BRC7C812

INSTALLATION MANUAL

Read these instructions carefully before installation.

Keep this manual in a handy place for future reference.

This manual should be left with the equipment owner.

Wireless Remote Controller Kit

Summary of content (6 pages)

PAGE 1
INSTALLATION MANUAL Wireless Remote Controller Kit MODELS BRC7C812 Read these instructions carefully before installation. Keep this manual in a handy place for future reference. This manual should be left with the equipment owner.
PAGE 2
Wireless Remote Controller Kit CONTENTS 1. 2. 3. 4. 5. 6. 1. SAFETY CONSIDERATIONS.......................................... 2 BEFORE INSTALLATION ................................................ 2 REMOTE CONTROLLER INSTALLATION ...................... 2 RECEIVER INSTALLATION............................................. 3 FIELD SETTING .............................................................. 4 TEST OPERATION..........................................................
PAGE 3
• The direct transmitting distance of the remote controller is approximately 23 ft.. • The signal cannot be transmitted if something such as curtains blocks the receiver and the remote controller. • Installing to a wall or a pillar 1. Fix the remote controller holder (3) with the screws (6). CAUTION Change the setting so that the internal electronic equipments are not damaged with a pen etc.
PAGE 4
(2) Pull the relay harness from the receiver (1) up to where the clamp (10) meets the stopper, as shown above. (Refer to (2) in drawing) (3) Install the receiver (1) where the decoration corner panel was. Proceed in the opposite order in which you removed the corner panel. (Refer to (3) in drawing) (4) Fit the relay harness under the tab on the decoration panel and connect it to connector X24A on the indoor unit PC board.
PAGE 5
(2) Select the desired MODE NO. with the “ (3) Push the “ (4) Push the “ NO.. (5) Push the“ are set. UP MODE ” button. ” button and select the FIRST CODE NO.. DOWN ” button and select the SECOND CODE RESERVE (Example) If the time to clean air filter is set to “Filter Contamination-Heavy”, set Mode No. to “10”, FIRST CODE NO. to "0", and SECOND CODE NO. to “02”.
PAGE 6
3P155845-2C EM05A002A (0504) FS