Service manual

Instruction SiENBE12-522A
150 System Configuration
"
To start COMFORT AIRFLOW operation
3. Press “COMFORT AIRFLOW button”.
The flap position will change, preventing air from blowing directly on the occupants of the room.
• “ ” is displayed on the LCD.
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
"
To cancel COMFORT AIRFLOW operation
4. Press “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
Notes on COMFORT AIRFLOW operation
Notes on flaps and louvers angles
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time.
Priority is given to POWERFUL operation.
• When “ SWING button ” is selected, the flaps
swinging range depends on the operation mode.
(See the figure.
)
#
##
" ATTENTION
• Always use a remote controller to adjust the flaps
angle. If you attempt to move it forcibly with hand
when it is swinging, the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the
air outlet, a fan is rotating at a high speed.
5˚
In DRY mode or COOL mode
In HEAT mode
When stop operation
Upper limit
Lower limit
10˚
50˚
30˚
65˚
When stop operation
Upper limit
Lower limit
In FAN mode
70˚
When stop operation
Upper limit
Lower limit