Service manual

SiENBE12-522A Instruction
System Configuration 133
■
Outdoor Unit
■
■■
■
Indoor Unit
1. Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
•
These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front grille
5. Grille tab
6. INTELLIGENT EYE sensor:
•
It detects the movements of people and
automatically switches between normal operation
and energy saving operation.
7. Display
8. Air outlet
9. Flap (horizontal blade)
10. Louvers (vertical blades):
• The Louvers are inside of the air outlet.
11. Operation lamp (green)
12. TIMER lamp (yellow)
13. HOME LEAVE lamp (red):
•
Lights up when you use HOME LEAVE
Operation.
14. Indoor Unit ON/OFF switch:
•
Push this switch once to start operation.
Push once again to stop it.
• The operation mode refer to the following table.
• This switch is useful when the remote controller
is missing.
15. Packaging materials:
50 class only
•
If any packaging materials are included,
please remove before operating.
16. Room temperature sensor:
•
It senses the air temperature around the unit.
17. Signal receiver:
•
It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
■
■■
■
Outdoor Unit
18. Air inlet:
(Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
21. Drain hose
22. Earth terminal:
• It is inside of this cover.
Appearance of the outdoor unit may differ from some models.
20
21
22
19
18
Mode
Temperature
setting
Air flow
rate
FTKS COOL
22
°
C
AUTO
FTXS AUTO
25
°
C
AUTO