Installation manual

7 English
AIR FLOW DIRECTION ADJUST
Press the AIR FLOW DIRECTION button to adjust
the air fl ow angle.
Up and down adjustment
The movable limit of the fl ap is changeable. •
Contact your dealer for details.
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as shown
below.
swing
The AIR FLOW FLAP display
swings as shown below and the
air fl ow direction continuously
varies. (Automatic swing setting)
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air fl ow
direction is fi xed (Fixed air fl ow
direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air fl ow direction so it may be different
from the display.
Operation
mode
Cooling Heating
Operation
condition
When room •
temperature is
lower than the
set temperature
When operating •
continuously at
horizontal air
fl ow direction
When room •
temperature is
higher than the
set temperature
At defrost opera-•
tion
Operation mode includes automatic operation.
PROGRAM TIMER OPERATION
Operate in the following order.
The timer is operated in the following two ways.•
Programming the stop time ( • ) .... The
system stops
operating after the set time has elapsed.
Programming the start time ( •
) .... The sys-
tem starts
operating after the set time has elapsed.
The timer can be programmed a maximum of •
72 hours.
The start and the stop time can be simultane-•
ously programmed.
1
TIMER MODE START/STOP
Press the TIMER MODE START/STOP
button several times and select the mode
on the display.
The display fl ashes.
For setting the timer stop .... “
”
For setting the timer start .... “
”
2
PROGRAMMING TIME
Press the PROGRAMMING TIME button and
set the time for stopping or starting the
system.
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
3
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “
or ” changes from fl ash-
ing light to a constant light.
Refer to fi gure 4 on page [1]
NOTE
When setting the timer Off and On at the same •
time, repeat the above procedure from
1
to
3
once again.
01_EN_3PN07753-10N.indd 701_EN_3PN07753-10N.indd 7 12/18/2008 7:39:14 PM12/18/2008 7:39:14 PM