Service manual

ESIEN05-04 Disassembly and Maintenance
Part 5 – Disassembly and Maintenance 5–103
3
5
1
5
3 Disconnect wires and
connectors from PCB.
4 Arrange wire harness to
avoid interference with
next process.
Caution:
This work should be done by two
personnel.
If drain water remain in the pan, it
may drop and stain on the floor.
Make sure to check if no drain
water remain in the pan, or cover
the floor with vinyl sheet before
disassembling work.
5 To dismount drain pan
blocking plate, remove
each two mounting
screws located at four
corners.
Step
Procedure Points