User`s manual

1413
BRC7C610W
A signal receiver must be added to the indoor unit.
Wireless LCD remote controller
Wireless remote controller and signal
receiver unit are sold as a set.
Signal receiver unit (Installed type)
Comfortable
Easier to install and service
Dehumidification is micro processor controlled to prevent abrupt and
uncomfortable changes in air temperature.
Maintenance possible from the front of the unit
All maintenance tasks can be carried out via front access. During service
work, attachment and detachment of parts is easier.
Low gas pressure detection
Insufficient gas charging is normally hard to detect. During post-
installation trials and regular inspection procedures, the refrigerant level
is monitored by computer to ensure proper gas pressure.
Programme "Dry"
Switchable fan speed: High/Low
••••• ••••••••••••• •••• •
Heat pump
Mould
prevention
Comfort Work & Servicing Control features Others
Feature
Features
Model
*1
*
1
Applicable when wired remote controller is used
WALL MOUNTED TYPE
Switchable fan speed
Auto swing
Programme "Dry" High fan speed mode
Draft prevention function
Hot start Year-round cooling applicable Timer selector Pre charged for up to 30 m Mould-proofing drain pan Mould-resistant treatment for filter Filter sign Low gas pressure detection Emergency operation Self-diagnosis function Control by 2 remote controllers Auto-cooling/heating change-over Auto-restart PE fin Control by 1 remote controller External command control Central remote control Interlock control
Two selectable thermo-sensors
Two selectable temperature-sensors
* Temperature-sensor on indoor unit must be used when the air conditioner is controlled from another room.
**Wireless remote controller does not have a temperature-sensor.
Auto-swing Auto-blow direction control 5-level blow direction setting
10°
70°
Auto-swing
from 10° to 70°
Gettable to 5
different levels
between 10° to 70°
Last blow direction is
saved in memory and
automatically set
the next time the unit is
turned ON.
(factory setting is 10° for cooling
and 70° for heating.)
10°
70°
10°
70°
Improved air discharge modes ensure comfortable
air distribution across the entire room
Both indoor unit and wired remote controller (option) contain temperature-
sensors. Temperature sensing can be set at the unit or, to further improve
comfort level, closer to the target area at the wired remote control.
This feature must be set during commissioning by the technicians.
Comfort even on the far side of the room
To carry air to the far side of long
rooms, extra-high air blow adds
10% more fan speed the "high"
setting. Air discharge strength is
selected from the remote
controller.
Note: Remote controller cable not
included. Cables must be
procured locally.
Wired LCD remote controller
with weekly schedule timer
BRC1D61
Accessory required for indoor unit
Option
FAQ100BV
Heat pump