Specifications

Main Functions SiBE04-624
56 Function and Control
2.26 Table for Special Modes

Operation of indoor unit ON/OFF button and buttons of remote controller
To enter a specific mode, press one of the buttons below for more than 5 sec.
A. Diagnosis mode is improved to enable one-touch indication by applying two-way
communication.
B. Forced operation mode is the same as the conventional one. (But buzzer beeps, timer and
multi-monitor illuminate)
C. In indoor unit demonstration mode, the color of multi monitor changes regularly and the
sequence of events (front panel open → flaps swing → front panel close) repeats.
It takes about 10 minutes for 1 period.
D. In humidifying demonstration mode, the color of the multi-colored indicator changes
regularly.
Select “URURU” HUMIDIFYING or HUMID HEATING for demonstration.
(This mode can be used for demonstration of humidification operation at shops.)
E. Trial operation mode is improved in such a way that the conventional 3 buttons to be
pressed simultaneously are integrated into one button.
The time to start compressor can be set by “ (forward)” button by 0 min., 1 min. or 3 min.
later.
Select the desired operation mode to start operation.
Normal mode Normal mode
A. Diagnosis mode
B. Forced operation mode
E. Trial operation mode
*Hose length
setting
D.Humidifying
demonstration mode
F. Humidifying hose length
setting mode
G. Forced humidifying drying mode
H. Humidifying air flow rate
fine adjusting mode
Stop
[CANCEL] button or leave it
for 60 sec.
[ON/OFF] button or leave it
for 15 min.
[ON/OFF] button or leave it for 30 min.
[CLOCK] button or leave it for 30 min.
[CLOCK] button or leave it for 60 sec.
transmission
abnormal
[indoor ON/OFF]
button
transmission
abnormal
[indoor ON/OFF]
button
transmission
normal
[indoor ON/OFF]
button
[CLOCK] button
or leave it for
60 sec.
transmission normal
[Indoor ON/OFF] button
[CANCEL] button
[ON/OFF]
button
[ON/OFF] button
Power reset
Power reset
C.
Indoor unit
demonstration
mode
(R6029)
[CLOCK] button
Mode selection
view
Select by
(forward/back)
button, and press
the "CLOCK"
button.