Series Installation Manual
Table Of Contents
- Warnings, environmental policy, and certifications
- System description
- Description, installation and connection of the components
- Initial configuration
- Advanced configuration
- User settings – Wired Thermostat
- Zone settings
- Commissioning steps
- Exception codes
- Auto diagnostics
- Navigation guide
- Troubleshooting
- Wiring diagram
- Página en blanco
21
Installation Manual
Rev. 2.00 Date 01-2019
Note: check with BMS vendor
what device ID should be
configured here to avoid conflict
within BACnet network.
DZK BACNET INTERFACE
Installation
The DZK BACnet Interface is a Plug&Play interface. Disconnect the
terminal and snap the connector and the interface support tube as
shown in the pictures:
Note: This BACnet/IP device is connected to the BMS by Ethernet cable.
BACnet typical layouts are as follows:
Configuration
From the main screen, press and hold the icon until the “Enter
pattern” screen is displayed. Enter the sequence below to access
the configuration menu, select the System settings and then
select the BACnet setting.