Technical data
3
• Systems • Control Systems
7
• Individual control systems
3 BRC3A61 - Simplified remote control for hotel applications
3-2 Explanation of buttons and functions
NOTES
1 Please note that the display shows all indications for the purpose of explanation only.
This is contrary to actual running situations.
2 This remote controller does not have “AIR FLOW DIRECTION ADJUST BUTTON.” Don’t operate the flap adjusting air flow direction by your hand.
(FXFQ, FXCQ, FXAQ, FXKQ)
1
ON/OFF BUTTON
7
DISPLAY ‘ ’ (FAN SPEED)
Press the button and the system will start. Press the button again and the system will stop. The display shows the set fan speed: ‘HIGH’ or ‘LOW’.
2
OPERATION LAMP (RED)
8
DISPLAY ‘ ’ (DEFROST/HOT START)
The lamp lights up during operation or blinks if a malfunction occurs.
Indicates that defrost or hot start (during which the fan is stopped till the temperature of air supply rises enough
at the start of a heating run) is in progress.
3
DISPLAY “ “,” ” (VENTILATION / AIR CLEANING)
9
TEMPERATURE SETTING BUTTON
This display shows that the total heat exchange unit is in operation.
(These is an optional accessory).
Use this button for SETTING TEMPERATURE of the thermostat.
▲
; Each press raises the set temperature by 1°C.
▼
; Each press lowers the set temperature by 1°C.
The variable temperature range is 16°C tot 32°C.
4
DISPLAY ‘ ’ (SET TEMPERATURE)
This display shows the set temperature. Only given during a cooling or heating operation.
5
DISPLAY ‘ ’ ‘ ’ ‘ ’ ‘ ’ ‘ ’ (OPERATION MODE)
10
FAN SPEED CONTROL BUTTON
This display shows the current OPERATION MODE.
‘’ is not available with outdoor units specially designed for cooling only.
‘’ is reserved only for heat recovery outdoor units.
Press this button to select the fan speed, HIGH or LOW, of your choice.
11
DISPLAY ‘ ’ (MALFUNCTION)
Indicates malfunction and blinks if the unit stops operating due to the malfunction.
(As for details, see “TROUBLE SHOOTING” in the operation manual attached to the indoor unit.)
6
DISPLAY ‘ ’ (UNDER CENTRALIZED CONTROL)
When this display shows, the system is UNDER CENTRALIZED CONTROL. (This is not a standard specification)
C
C