Manualshelf

Technical data

ManualsBrandsDaikin ManualsRemote ControlBRC4C63
11121314151617181920
• Individual control systems
6
• Systems • Control Systems
14
6 BRC7C62,67 - Infrared remote control
6-2 Explanation of buttons and functions
NOTES
1 Please note that the display shows all indications for the purpose of explanation only.
This is contrary to actual running situations.
2 Figure 2 shows the remote control with the front cover opened.
1
DISPLAY ‘’ (SIGNAL TRANSMISSION) 13 TIMER RESERVE/CANCEL BUTTON
This lights up when a signal is being transmitted. 14 AIR FLOW DIRECTION ADJUST BUTTON
2
DISPLAY ‘ ’ ‘ ’ ‘ ’ ‘ ’ ‘ ’ (OPERATION MODE)
15
OPERATION MODE SELECTOR BUTTON
This display shows the current OPERATION MODE. For cooling only type, ‘ ’ (Auto) and ‘ ’ (Heating) are
not installed.
Press this button to select OPERATION MODE.
16 FILTER SIGN RESET BUTTON
3
DISPLAY ‘ ’ (SET TEMPERATURE)
17
INSPECTION/TEST OPERATION BUTTON
This display shows the set temperature. This button is used only by qualified service persons for maintenance purposes.
4
DISPLAY ‘ ’ (PROGRAMMED TIME)
18
EMERGENCY OPERATION SWITCH
This display shows PROGRAMMED TIME of the system start or stop. This switch is readily used if the remote control does not work.
5 DISPLAY ‘ ’ (AIR FLOW FLAP)
19
RECEIVER
6
DISPLAY ‘ ’ (FAN SPEED) This receives the signals from the remote control.
The display shows the set fan speed.
20
OPERATING INDICATOR LAMP (RED)
7
DISPLAY ‘ ’ (INSPECTION/TEST OPERATION) This lamp stays lit while the air conditioner runs. It flashes when the unit is in trouble.
When the INSPECTION/TEST OPERATION BUTTON is pressed, the display shows the system mode is in.
21
TIMER INDICATOR LAMP (GREEN)
8
ON/OFF BUTTON This lamp stays lit while the timer is set.
Press the button and the system will start. Press the button again and the system will stop.
22
AIR FILTER CLEANING TIME INDICATOR LAMP (RED)
9
FAN SPEED CONTROL BUTTON Lights up when it is time to clean the air filter.
Press this button to select the fan speed, HIGH or LOW, of your choice.
23
DEFROST LAMP (ORANGE)
10
TEMPERATURE SETTING BUTTON Lights up when the defrosting operation has started. (For straight cooling type this lamp does not turn on.)
Use this button for SETTING TEMPERATURE. (Operates with the front cover of the remote control closed.)
24
FAN/AIR CONDITIONING SELECTOR SWITCH
11
PROGRAMMING TIMER BUTTON Set the switch to “ “ (FAN) for FAN and “ “ (A/C) for HEAT or COOL.
Use this button for programming “START and/or STOP” time. (Operates with the front cover of the remote control closed.)
25
COOL/HEAT CHANGEOVER SWITCH
12 TIMER MODE START/STOP BUTTON Set the switch to “ “ (COOL) for COOL and “ “ (HEAT) for HEAT.
C
H • M • L