Technical data
• Sky Air • Control Systems
7
• Individual control systems
1
2
2 BRC2C51 - Simplified remote control
2 - 1 Explanation of buttons and functions
NOTE
1 Please note that the display shows all indications for the purpose of explanation only.
This is contrary to actual running situations.
1
ON/OFF BUTTON
8
DISPLAY ‘ ’ (FAN SPEED)
Press the button and the system will start. Press the button again and the system
will stop.
The display shows the fan speed: “HIGH” or “LOW”.
2
OPERATION LAMP (RED)
9
DISPLAY ‘ ’ (DEFROST/HOT START)
The lamp lights up during operation and blinks in case of stop due to malfunction. Indicates that defrost or hot start (during which the fan is stopped till the
temperature of air supply rises enough at the start of a heating run) is in progress.
3
DISPLAY ‘ ‘ (CHANGEOVER UNDER CONTROL)
It is impossible to changeover heat/cool with the remote control when it shows this
display. (As for details, see “SETTINGS OF MASTER REMOTE CONTROL” in
the operation manual attached to the indoor unit.).
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE of the thermostat.
; Each press raises the set temperature by 1°C.
; Each press lowers the set temperature by 1°C.
The variable temperature range is 16°C tot 32°C.
4
DISPLAY “ “,” ”,”OPTION” (VENTILATION / AIR CLEANING)
This display shows that the total heat exchange unit and the air cleaning unit are
in operation. (These are optional accessories.).
5
DISPLAY ‘ ’ (SET TEMPERATURE)
11
FAN SPEED CONTROL BUTTON
This display shows the set temperature. Only given during a cooling or heating
operation.
Press this button to select the fan speed, HIGH or LOW, of your choice.
6
DISPLAY ‘ ’ ‘ ’ ‘ ’ ‘ ’ ‘ ’ (OPERATION MODE)
12
OPERATION MODE SELECTOR BUTTON
This display shows the current OPERATION MODE.
‘ ’ is not available with outdoor units specially designed for cooling only.
‘ ’ is reserved only for outdoor units capable of heat recovery.
Press this button to select OPERATION MODE.
13
DISPLAY ‘ ’ (MALFUNCTION)
Indicates malfunction and blinks if the unit stops operating due to the malfunction.
(As for details, see “TROUBLE SHOOTING” in the operation manual attached to
the indoor unit.)
7
DISPLAY ‘ ’ (UNDER CENTRALIZED CONTROL)
When this display shows, the system is UNDER CENTRALIZED CONTROL.
(This is not a standard specification)