Technical data
• Sky Air • Network Solution
49
•
DS
DS
ne
tnet
DS
ne
t
3
4
4 Electric wiring
The contact is constant contact. The output conditions are level reading.
• When the forced operation contact is closed, all stopped units are continuously instructed to operate.
• When the forced stop contact is closed, all operating units are continuously instructed to stop.
• Once the forced operation contact is closed, all indoor units which are stopped at that time are instructed to operate, even if the forced stop contact
is closed immediately after, the indoor units will operate for a moment and then stop. (This is the same as with the remote control operation.)
The contact is to be purchased locally. The current applied when the contact is ON is approx. DC16V, 10mA. Input is via momentary A-contact.
Minimum 1 second is required for turning ON. Please don’t clamp with high voltage cable.
Electrical wiring
Procured on-site sheathed vinyl cord
(VCTF 0.2 mm
2
or 0.3 mm
2
)
Important
• The A (+) and B (-) terminals have polarity which must not be mixed up.
• Turn on SS1 (terminating resistance) for the DS-NET adapter.
• Leave the adapter address of the circuit board to 0.