Technical data

• Sky Air • Centralised Control systems
35
• Centralised control systems
2
2
2 DCS302C51: Centralised remote control
2 - 2 Explanation of buttons and functions
NOTES
1 Please note that the display shows all indications for the purpose of explanation only.
This is contrary to actual running situations.
2 If the unit is used in conjunction with other optional centralised control systems, the operation lamp of the unit that is not under operation control
may light up and go out a few minutes behind schedule. This shows that the signal is being exchanged, and does not indicate any failure.
32
FILTER SIGN RESET BUTTON
36
INSPECTON/TEST RUN BUTTON (FOR SERVICE)
This button is pressed to erase the “clean filter” display after cleaning or replacement. Pressing this button scrolls through “inspection”, “test run”, and “system display”.
This button is not normally used.
33
SET BUTTON
Sets control mode and time No.
37
VENTILATION STRENGTH ADJUSTMENT BUTTON
34
FAN STRENGTH ADJUSTMENT BUTTON This button is pressed to switch the ventilation strength (“fresh up”) of the total enthalphy heat exchanger.
Pressing this button scrolls through “weadé, “strong”, and “fast”.
35
ZONE SETTING BUTTON
Zone registration mode can be turned on and off by pressing the start and stop buttons
simultaneously for at least four seconds.
ALL
OPTION
OPTION
L
NO
NOT
AV
AILABLE
AILABLE
SET
FRESH UP
FRESH UP
H
HH
HH
No
No.
CODE
CODE
UNIT No.
TEST
INDIVIDUALLY
C
F
12
( 1 ) (11)( 3 )( 9 )(10)
( 4 )
( 5 ) ( 6 ) ( 7 )
( 8 )
(16) (17) (15) (19)
(20)
(21)
(14)
(13)
(12)
(18) (22)
( 2 )
(23)
(24)
(36) (35) (27) (34) (33) (32)
(26) (28) (29) (30) (31)
(37)
(25)