Technical data

73
• Control systems
• intelligent Touch Manager • ED721208
Terminals location and conceptual connection diagram
Using a LAN cable, connect the LAN socket to the network hub.
<Conceptual drawing of LAN connection>
E
E
A Rear face of iTM integrator
B LAN cable
C Hub
D PC
E intelligent Touch Manager
Requirements that must be met
•Applicablecablestandard:100Base-TXor10Base-T
•Connectorstandard:RJ-45
<SERVICE LAN socket and LAN SW switch>
NOTE
•IfyouareconnectingtoaLANtemporarilyduring
installation or maintenance, use the SERVICE LAN
terminal located on the front face.
Changing the position of the LAN SW switch to “FRONT”
causes the SERVICE LAN socket to activate (enabled for
use).
•Youcannotclosethecoverwhentheswitchsetto
“FRONT”. To close the cover, select “BACK”.
A SERVICE LAN
B LAN SW