Technical data

• Control systems

• intelligent Touch Manager • ED721208

3.3.4. Connections

This chapter describes the procedure for connecting the iTM integrator with the intelligent Touch Manager.

Required procedures •2.3Connectingpowersupply

•2.2ConnectingaLANcable

WARNING

• Do not turn the power supply on until all connections are made. Also, make sure that the

local circuit breaker, if available, is turned off. Not doing so may cause an electric shock.

• After completing connections, check again that all wires are connected correctly before

turning on the power supply.

• All field supplied parts and materials, electric works must conform to local codes.

• All wiring must be performed by an authorized electrician.

Removing terminal cover from rear face

Before you start any of these connection procedures, remove

the terminal cover from the rear face. To do so, remove two

screws using a Phillips screwdriver.