Technical data

67
• Control systems
• intelligent Touch Manager • ED721208
3.3.2. Locations of terminals and switches
Understand the arrangement of terminals and the location of openings on the unit and plan how to route the cable and in which order
to connect its wires to facilitate the installation procedure. For connection details including the cable type and terminal size, refer to “2.
Connection”.
Rear face
Most terminals are located on the rear face of the iTM integrator. However, they are covered with a terminal cover for safety reasons.
Removing 2 screws to detach this cover reveals various types of terminals as shown below.
<Rear face of iTM integrator>
A [POWER] The power line connection terminals. A power supply voltage of 100 to 240 VAC (at 50/60 Hz) is required. Near this
terminal block, there is a blue resin cable mount used for securing the power supply cables with cable ties.
B [DIII] No Use.
C [LINE, PHONE] No Use.
D [RESERVE] No Use.
E [RS-485] No Use.
F [plus ADP IF] No Use.
G [Di (1-4), COM] No Use.
H [LAN] The socket for connecting the iTM integrator to an Ethernet network.