Technical data

• Control systems

• intelligent Touch Manager • ED721208

Terminals location and conceptual connection diagram

Using a LAN cable, connect the LAN socket to the network hub.

A Rear face of intelligent Touch Manager

B LAN cable

C Hub

D PC

Requirements that must be met

•Applicablecablestandard:100Base-TXor10Base-T

•Connectorstandard:RJ-45

<SERVICE LAN socket and LAN SW

switch>

NOTE

•IfyouareconnectingtoaLANtemporarilyduring

installation or maintenance, use the SERVICE LAN

terminal located on the front face.

Changing the position of the LAN SW switch to “FRONT”

causes the SERVICE LAN socket to activate (enabled for

use).

•Youcannotclosethecoverwhentheswitchsetto

“FRONT”. To close the cover, select “BACK”.

A SERVICE LAN

B LAN SW