Specifications
ED04-805 Installation Manual
Room Air Conditioners E-Series 29
1. Indoor unit.
• The indoor unit should be sited in a place where:
1) the restrictions on installation specified in the indoor unit installation drawings are met,
2) both air intake and exhaust have clear paths met,
3) the unit is not in the path of direct sunlight,
4) the unit is away from the source of heat or steam,
5) there is no source of machine oil vapour (this may shorten indoor unit life),
6) cool (warm) air is circulated throughout the room,
7)
the unit is away from electronic ignition type fluorescent lamps (inverter or rapid start type) as they may shorten the remote controller range,
8)
the unit is at least 1 metre away from any television or radio set (unit may cause interference with the picture or sound),
9) install at the recommended height (1.8m).
2. Wireless remote controller.
1) Turn on all the fluorescent lamps in the room, if any, and find the site where remote controller signals are
properly received by the indoor unit (within 7 metres).
1. Removing and installing front panel.
• Removal method
Hook fingers on the panel protrusions on the left and right
of the main body, and open until the panel stops. Slide
the front panel sideways to disengage
the rotating shaft. Then pull
the front panel toward you
to remove it.
• Installation method
Align the tabs of the front panel with the
grooves, and push all the way in. Then
close slowly. Push the center of the
lower surface of the panel firmly to
engage the tabs.
• Before choosing the installation site, obtain user approval.
2. Removing and installing front grille.
• Removal method
1)
Remove front panel to remove the air filter.
2)Remove the front grille.
3)
In front of the mark of the
front grille, there are 3 upper
hooks. Lightly pull the front grille
toward you with one hand, and
push down on the hooks with
the fingers of your other hand.
<When there is no work space because the unit is close to ceiling>
Be sure to wear protection gloves.
CAUTION
Place both hands under the center of the front
grille, and while pushing up, pull it toward you.
• Installation method
1)
Install the front grille and firmly engage the upper hooks (3 locations).
2) Install 2screws of the front grille.
3) Install the air filter and then mount the front panel.
3. How to set the
different addresses.
When two indoor units are
installed in one room, the
two wireless remote
controllers can be set for
different addresses.
1) In the same way as
when connecting to an
HA system, remove the
metal plate electrical
wiring cover.
2) Cut the address jumper
(JA) on the printed
circuit board.
3) Cut the address jumper
(J4) in the remote
controller.
A
B
C
D
E
F
G
H
J
K
L
Mounting plate
Titanium Apatite Photocatalytic
Air-Purifying Filter
Wireless remote controller
Remote controller holder
AAA dry-cell batteries
Indoor unit fixing screws
M4 × 12L
Operation manual
Installation manual
Mounting plate fixing
screws M4 × 25L
Fixing screws for remote
controller holder M3 × 20L
Insulation tape
Accessories
Choosing an Installation Site
Installation Tips
Push the
rotating shaft
of the front
panel into the
groove.
{{{ mark area
(3 locations)
Upper hook
Lightly pull the front
grille toward you with
one hand, and push
down on the hooks with
the fingers of your other
hand. (3 locations)
Push
down.
Upper hook
Upper hook
1) Push up.
2) Pull toward you.
ADDRESS
JA
ADDRESS
JA
EXIST
1
CUT 2
ADDRESS
J4
EXIST
CUT
1
2
J4
1
6
2
1
1
2
2
1
1
1
2