Use and Care Manual

ManualsBrandsDAICH Hi-Build Ultra ManualsPaint1 gal. Satin Clear Coat Sealer Water and Chemical Resistant with Urethane

Hi-Build Ultra™ Clear Coat with Urethane is a high-performance, one-component 35% solids acrylic/urethane

hybrid coating used over many interior and exterior surfaces.

An ideal top coat for concrete and masonry – as well as all DAICH Coatings stone ﬂoor ﬁnishes – Hi-Build

Ultra produces a tough, non-yellowing barrier that resists abrasion, impact, stains, chemicals and more.

Hi-Build Ultra is a safe, non-toxic, low odor water-based technology

excellent for residential, commercial and light industrial ﬂoor surfaces.

PREPARATION:

Surface must be clean and dry, free from dust, dirt, oils, loose ﬂaking, poorly

bonded or glossy paint, glue, surface sealers, efﬂorescence, etc.

Concrete Surface Preparation:

Pressure wash the concrete or vigorously scrub the surface with a strong TSP

and water solution. Rinse the surface thoroughly and remove wash water with adequate drainage or water-

compatible vacuum. Very smooth, new or efﬂorescent surfaces may need to be acid etched prior to general

cleaning (ask a qualiﬁed source for full instructions). Remove resulting etching residue thoroughly before

coating application. New concrete – allow 30 day cure before coating. New masonry – Cure 48 hours. Allow

the surface to dry completely.

DAICH Decorative Finishes – Surface Preparation:

Surface must be fully cured (at least 24 hours), clean and dry. Remove dirt or loose debris before sealing.

APPLICATION:

Apply uniformly onto the surface using a 3/8” pile roller. Surface should be dry for 24 hours before

applying sealer. Temperature should be at least 50º F during application and for the next 12 hours. Apply

in dry conditions in the morning or late afternoon. Do not apply if rain is expected within 24 hours or take

precautionary measures to shield area from rain. Wash tools with soap and water when ﬁnished.

If applying to a Daich Spreadable Stone ﬁnish, ensure that the surface beneath is fully cured prior to

application of Hi-Build Ultra. Re-apply until desired ﬁlm-build is achieved - and ONLY when previous coats

have dried through (at least 8 hours - longer in damp, humid or cool conditions, and/or where there is little air

circulation). On very smooth surfaces, scuff previous coatings lightly before application. Do not step on surface

while it is tacky. Rope off the sealed area to allow curing and discourage normal foot trafﬁc for 24 hours.

COVERAGE: Up to 400 sq.ft. per gallon. Coverage varies with surface roughness and application thickness.

Two coats recommended.

CONTAINER SIZES: Hi-Build Ultra Clear Coat Sealer is available in 1-gallon and 5-gallon containers.

STORAGE: May be stored in its original unopened container for two years.

PRECAUTIONS:

Avoid contact with eyes and skin, ﬂood eyes repeatedly with potable water for 15 minutes. Wash hands

thoroughly after handling. Do not take internally. KEEP OUT OF REACH OF CHILDREN. Keep container closed.

Water-based product. Dispose of unused material as prescribed by local laws.

Hi-Build Ultra Performance Features

• water / weather resistant

• UV resistant

• excellent chemical resistance

• very low odor

• water-based

• glossy ﬁnish

• salt resistant

• impact resistant

• abrasion resistant

• mold and mildew resistant

• non-yellowing

• low VOC

PRODUCT DATA SHEET

Multi-Purpose

Sealer with Urethane