Specifications

Telit GM862-PCS/-GPRS/-GSM Product Description
1vv0300604, Rev. ISSUE#14 - 22/01/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 158 of 214
6.7.1.2 #SRS - Select ringer sound
#SRS – select ringer sound
Execute command
AT#SRS =
<n>[,<timeout>]
Set the ringer sound. The parameters are:
<n> - ringing tone
0 - current ringing tone
1 .. 12 - ringing tone number
<timeout> ringing tone playing timeout in seconds.
0 - no ringing tone playing, only tone setting
1 .. 60 - <n> tone playing for <timeout> seconds and successive
tone setting.
Note: When the command is issued with <timeout> >0, the <n>
ringing tone is played for <timeout> seconds and then stored as current
tone.
If command is issued with <timeout> = 0, the playing of the ringing is
stopped (if present) and <n> ringing tone is set as default.
If command is issued with <n> = 0 and <timeout> >0 then the default
ringing tone is played.
If both <n> and <timeout> are 0 then currently playing tone is set as
default and ringing is stopped.
Read command
AT#SRS?
Reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> ringing tone number
1 .. 12
<status> ringing status
0 - selected but not playing
1 - currently playing
Write command
Test command
AT#SRS=? Reports the supported values for the parameters <n> and <timeout>
Example
Reference Telit GM862-GPRS AT Command Specification
SW release Version A