Operation Manual

Dahua Network Camera Web 3.0 Operation Manual

5.1.1.2 Exposure

Step 1

Select “Setup > Camera > Conditions > Exposure”. The system will display the “Exposure” interface

which is shown in Figure 5-2.

Figure 5-2

Step 2

It is to set the exposure parameter, please refer to the following sheet for more details.

Parameter

Note

Anti-flicker

 You can switch to exposure mode when it is in outdoor

mode, it can realize the result in the corresponding exposure

mode.

 50Hz: When the current is 50Hz, system can auto adjust the

exposure according to the environment brightness in case

there is any stripe.

 60Hz: When the current is 60Hz, system can auto adjust the

exposure according to the environment brightness in case

there is any stripe.