Operation Manual

Dahua Network Camera Web 3.0 Operation Manual
131
The PTZ settings interface is shown as in Figure 5-109.
Figure 5-109
Please refer to the following sheet for detailed information.
Parameter
Function
Protocol
Select the corresponding dome protocol.
Address
Set corresponding dome address. Default value is 1.
Please note your setup here shall comply with your dome address;
otherwise you cannot control the speed dome.
Baud
Rate
Select the dome baud rate. Default setup is 9600.
Data Bit
Default setup is 8.
Stop bit
Default setup is 1.
Parity
Default setup is none.
5.5.4 Default
The default setup interface is shown as in Figure 5-110.
Please note system cannot restore some information such as network IP address, account and so on.