Operation Manual

Dahua Network Camera Web 3.0 Operation Manual
111
Figure 5-80
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
After enabled, relay activation will work. Check it and enable the
PIR alarm.
Working
period
 This function becomes activated in the specified periods.
 There are six periods in one day. Please draw a circle to
enable corresponding period.
 Select date. If you do not select, current setup applies to
today only. You can select all week column to apply to the
whole week.
 Click OK button, system goes back to motion detection
interface; please click save button to exit.
Note: User can set via dragging mouse while not releasing left
mouse.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 100s.
Flash
After enabling, the system will automatically turn on the flash
when alarm occurs.
Flash Delay

The flash will be off with a period of time delay when the
alarm linkage is over.

Time is calculated by unit of second and ranges from
10s~300s.
Record
System auto activates motion detection channel to record once
alarm occurs (working with motion detection function).
Record Delay
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.